proposal to refer to en standards in chapter 6 8 of the adr

Economic and Social Council - UNECE

Executive summary:The purpose of this proposal is to introduce a reference to standard EN 13648-1 for safety valves of tanks intended for the carriage of refrigerated liquefied gases. Action to be taken:Add a reference to this standard in 6.8.2.6.1 of ADR. Related documents:INF.21/Rev.1 of March 2014, proposals 3 and 9;

INF - Homepage UNECE

6.8.2.3 need to be renewed. It therefore appears necessary to defer their mandatory application. Proposal In the list of amendments for RID/ADR 2009, amend the entries in the table of 6.8.2.6 for EN 14025 and EN 13094 to read as follows:Applicable sub-sections and paragraphs Reference Title of document Mandatory application for tanks INF. 6 RID/ADR/ADN - UNECEINF. 6 . 2 Proposal . 5. European Standard EN 12972 already referenced in RID/ADR 6.8.2.6 2 defines detailed requirements regarding welding on tanks. However, such responsibilities should not be de-fined in standards. 6. UIP therefore proposes to amend 6.8.2.1.23 as follows:After the first paragraph, insert the following paragraph:

INF.48 Economic Commission for Europe

Part 6, Chapter 6.8 Proposal 6 In RID/ADR, 6.8.2.6.1 add, in the Table the following new references: not be required by ADR/RID. This standard will replace EN 1251-2:2000 already referenced in 6.2.4.2. The standard WG will review the retention of the reference to this standard when it is withdrawn from the standards catalogue. - EN 71st session UNECENov 09, 2001 · TRANS/WP.15/71/INF.22 - (CEN) Proposal to refer to EN standards in chapter 6.8 of the ADR English:DOC:PDF TRANS/WP.15/71/INF.21 - (Secretariat) Corrections to Depositary Notification C.N.1078-TREATIES-3 of January 2001 English:DOC:PDF French:DOC:PDF TRANS/WP.15/71/INF.17 - (CEN) Presentation of a EN standard for future reference in chapter 6.8 of the ADR

We are the professional supplier who can meets all kinds of steel and fabrication requirements. If your required steel parts need cutting, welding, drilling, rolling, bending, forming, grinding, stamping and so on machining, we are ready to serve you.

Leave a comment: